chamfer

英 [ˈtʃæmfə(r)]

美 [ˈtʃæmfər]

n.  斜切面; 削角

复数：chamfers　现在分词：chamfering　过去分词：chamfered　过去式：chamfered　第三人称单数：chamfers　

COCA.44768

牛津词典

noun

• 斜切面；削角
  a cut made along an edge or on a corner so that it slopes rather than being at 90˚

英英释义

noun

• two surfaces meeting at an angle different from 90 degrees
  Synonym:bevelcant

verb

• cut a furrow into a columns
  Synonym:furrowchase
• cut a bevel on
  1. bevel the surface
  Synonym:bevel

双语例句

• In order to miniaturize the millimeter wave circuit system, this study improved the traditional chain SIW filter and brought forward a new type of compact configuration with chamfer angle.
  为了实现毫米波电路系统小型化，对传统链式SIW滤波器进行改进，提出了一种新型的带倒角的紧缩结构SIW滤波器。
• What is the nominal chamfer size?
  什么是公称倒角尺寸？
• Drag to add perpendicular lines with adjustable chamfer size.
  拖动此形状，可添加切角可调的垂直线。
• The effects of rolling parameters such as plate width, roll contours, chamfer and straight chamfer parameters on the contact pressure distribution were studied.
  研究结果表明，在轧制能力范围内，轧件越宽，轧辊采用凹辊型可以使辊身部的辊间压力分布更为均匀；
• Core drills. A core drill consists of the chamfer, body, neck, and shank, as shown in Fig.12.2.
  空心钻包括斜面、钻头体、钻颈和钻柄，如图12.2所示。
• Fit the sealing ring at the correct position in the vacuum pump so that it is flush with the lower edge of the chamfer in the rotor.
  将密封圈安装在真空泵的正确位置，以便密封圈与转子倒棱的下边缘平齐。
• Select those front edges and chamfer them then click apply and chamfer it again but this time with a lower value.
  选择前面的边并倒角，然后单击应用并以较低的值再次倒角。
• Carefully remove smaller edges or burrs on the chamfer of the crankshaft flange with an oilstone if necessary.
  如有必要，请用油石仔细去除曲轴法兰倒棱上的小边或毛刺。
• CHAMFER: The flat surface formed by cutting away the sharp edges of two meeting surfaces.
  倒角：两个表面相交处，通过切掉尖锐边缘形成的平面。
• Programming Method of Milling of Chamfer and Fillet Based on$ TC_DP
  基于＄TCDP铣削斜面及倒圆角的程序编制方法